Search found 11 matches

by D33@+H-Kn1gH+
Thu Dec 07, 2017 3:59 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Tip In Fuel
Replies: 1
Views: 1192

Tip In Fuel

Does the ECU continuously use the "Tip In Fuel ECT compensation" table and the "Tip In Fuel Throttle Compensation" table or is the "Tip In Fuel ECT compensation" only used during warming up? Thankss
by D33@+H-Kn1gH+
Fri Aug 25, 2017 10:11 am
Forum: FlashPro Manager
Topic: Overrun Injector Restart RPM (CUT)
Replies: 4
Views: 591

Re: Overrun Injector Restart RPM (CUT)

I don't understand what you mean. The RPM cannot be lower than the recovery point, but not have hit the recovery point and still be in cutoff. If it is lower than the recovery point then it will no longer be in cutoff. I will try to explain it better. If I accelerate and let go of the throttle befo...
by D33@+H-Kn1gH+
Fri Aug 25, 2017 5:54 am
Forum: FlashPro Manager
Topic: Overrun Injector Restart RPM (CUT)
Replies: 4
Views: 591

Overrun Injector Restart RPM (CUT)

In the help file I can see that the injectors switch off when the engine speed is higher than the cut table, and switch on again when the engine speed is below the recover table. What I don't understand is if the injectors still operate on overrun if the RPM is lower than the cut table's specific RP...
by D33@+H-Kn1gH+
Thu Jul 27, 2017 1:50 am
Forum: S2000 2006-2009 Americas/Europe/Asia
Topic: Injector Overrun Manifold Pressure Settings
Replies: 7
Views: 6180

Re: Injector Overrun Manifold Pressure Settings

Yes, the resume should be a couple of kpa higher than cut. I would not make any of numbers 0. TPS cut is fixed across rpm at around 0.5%. Should I set the value 3kpa lower than the maximum kpa value on overrun, in all "cut" cells? Or should I set each "cut" cell 3kpa lower than the individual value...
by D33@+H-Kn1gH+
Sat Jun 24, 2017 10:09 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Overrun Throttle Opening
Replies: 2
Views: 836

Re: Overrun Throttle Opening

R-12914 wrote:
Mon Jun 19, 2017 12:24 pm
Do you have a datalog of this issue?
What supercharger do you have?
I have a rotex C30-94 with blow off. As soon as I have some time available I will record and post a datalog
by D33@+H-Kn1gH+
Mon Jun 19, 2017 3:43 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Overrun Throttle Opening
Replies: 2
Views: 836

Overrun Throttle Opening

Is there any way to compensate with overrun throttle opening when is enabled? I have a supercharged Type R FN2 and when the setting is enabled the quickest i press the clutch and the higher the RPM when I press it the revs jump even further (300-400rpm more) from the point they were when i pressed ...
by D33@+H-Kn1gH+
Thu Mar 09, 2017 11:25 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Throttle flow vs opening
Replies: 6
Views: 1120

Re: Throttle flow vs opening

From what J35-Engine do you have exactly the Throttle Body?: https://en.wikipedia.org/wiki/Honda_J_engine I bought the throttle body from tegiwa. As far as I know the throttle is the same as the FD2 type R Then try the values from a FD2 calibration or the values from a Honda/Acura, where has a J35 ...
by D33@+H-Kn1gH+
Thu Mar 09, 2017 8:22 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Injector flow for Fuel/Dash adjustment for ID1000
Replies: 1
Views: 659

Injector flow for Fuel/Dash adjustment for ID1000

How should I properly adjust the fuel economy for injector flow for fuel and dash? I am using Injector Dynamics 1000cc
by D33@+H-Kn1gH+
Thu Mar 09, 2017 5:24 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Throttle flow vs opening
Replies: 6
Views: 1120

Re: Throttle flow vs opening

How should I adjust the values for the J35 throttle body flow? I have the throttle body installed after the supercharger Regarding the FP help: Calibration > Throttle > Throttle Flow vs Opening: In some situations the ECU will need to know the air flow past the throttle body for a certain throttle ...
by D33@+H-Kn1gH+
Thu Mar 09, 2017 5:20 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Throttle flow vs opening
Replies: 6
Views: 1120

Re: Throttle flow vs opening

R-12914 wrote:From what J35-Engine do you have exactly the Throttle Body?:
https://en.wikipedia.org/wiki/Honda_J_engine
I bought the throttle body from tegiwa. As far as I know the throttle is the same as the FD2 type R
by D33@+H-Kn1gH+
Thu Mar 09, 2017 4:15 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Throttle flow vs opening
Replies: 6
Views: 1120

Throttle flow vs opening

How should I adjust the values for the J35 throttle body flow? I have the throttle body installed after the supercharger