Hondata

seems to me your are in limp mode....

does anyone know what the 003 for the last 3 digits is? auto or manual? thanks

main thing it might clear up a couple or hoses i agree to each their own...............

For every 11 degrees Farenheit you cool your intake charge, that's approximately a 1 HP gain. Actually the air does have time to be heated by the throttle body. I should know, I'm an engineering student and have dealt with some Heat Transfer problems similar to this. A 1 HP increase may not be noti...

HP is only gained mechanically through cams, compression and how the intake and valves are setup.........the more air you move the more power you produce. you are naive if you think a lower intake temp won't give hp. cooler air = denser air. Denser Air = More Power. The difference may not be much, ...

Ouch. Ebay! :lol: Why ouch and how did you know i got it from E bay? where else am i suppose to get a JDM ECU thats non OBD? i only paid 2 bills for it. I was implying that you could unload it on ebay. I was under the assumption that you were looking to get an ECU for use with Hondata, seeing that ...

DaX wrote:

QUICKSILVER RACING wrote:PR3-JOO is pre OBD-1 with OBD1 style sockets. Not Hondata compatible.

Ouch. Ebay!

Why ouch and how did you know i got it from E bay? where else am i suppose to get a JDM ECU thats non OBD? i only paid 2 bills for it.

QUICKSILVER RACING wrote:PR3-JOO is pre OBD-1 with OBD1 style sockets. Not Hondata compatible.

ok and your point is? i wasnt asking OBD compatibility with Hondata, cause i thought my question was which ECU do i have from the code? im very well aware this is a non OBD ECU since both my car and B16A are too. thanks

my ECU reads PR3-J00 is this an auto or manual? the guy i got it from in Japan said its out of a 90 Integra XSI manual........thanks for any input.

oh ok thats what i thought...........being it doesnt have OBD port......

coolant bypass wont do crap..........and there isnt any gears or what so ever in the throttle plate........ :roll: its basically a placebo affect. granted you may gain a tiny bit or throttle response but thatas about it, and also it doesnt make the car warm up any slower..........been there done tha...

So if i have a Non OBD PR3 ecu i cant datalog? i know OBD1 and up has the OBD port........in which to connect a diag tool. what do i do if anything so i can connect a laptop?

I was wondering if you can bypass the need for a second oxygen sensor??? PR3 ecu, obd0 out of a JDM civic SIR -or can you just run a wire from the first o2 sensor to the input for the second o2 sensor on the ecu duplicating the signal???? any imput would be appreciated, thanks in advance. no you ha...

Hey peeps im doing a swap in my 89 integra to a B16 and was wondering if anyone knows the pinout to my ECU i believe its a PM7. Does it have a VSS pin? thanks