Hondata

Yes, on wot it shhould be deactivated, but i would like it to run cloosed loop until about 40-50% of throttle opening! so it stays about on 14-14.7 AFR, which is needed for this specific emmission test!

Thanks

here the map

Hello, I really need this going for a emmisions test here in Europe! This will be on rollers and most important is the acceleration from a bout 50 to 90 km/h. The problem is, that i want the closed loop to stay activated and make me a clean 14.7 up to a bout 50% of throttle opening. It works very fi...

Hello,

Can someone tell me how to attach a wideband sensor to a hondata S200. Are there specific one where the software is already programmed for the outputs of the sensor? Or can anyone be used?

Many thanks

Adil

here the calibration

Ok, sorry for that will include the calibration as soon as i get it on the usb stick. Now i tried to go the way another forum member here suggested. i tried to set the correction factors (maximun) to 0 in closed loop and tune then to the desired Afr's and to open up the correction later. Strangely w...

Hello, The car ( civic D16, turbo) is now more or less well tuned. In opel loop In low load areas i programmed it to a steady lambda 0.98. As soon as i try to run it on closed loop, with a target of lambda 1.00 its leans out competely. I don't know whats wrong as the needed correcture is minimal. Is...

Hello,

How can i change the scaling of the rpm range, as i have 1000Rpm steps in the higher rev range, which is to big..?

Thanks

Hello, Just installed my S300 on the Honda D16. Everything is working fien so far car works connection to ECU works fine. Now my question, what need to be activated that you see where u are right now (rpm, ignition, etc.) so that you see where exactly you are in the map ind different conditions? Rea...

anyone?

Sorry forgot to give the full details.

It's the D16 Z6, 120-125hp + v-tec

Hello,

I'm looking for a completely stock map for this engine has someone got one.

It's mainly due to the cold start etc, wich will be used for a biiger homologation test including emission zyklus test..

after a greddy Turbokit will be used, are calibrations for this kit existent?


Thanks