Search found 7 matches

by tune4food
Thu May 14, 2009 4:48 am
Forum: s300 / SManager
Topic: Smanager wish list
Replies: 150
Views: 164279

I think a kill switch or a password to access the ECU would be bad ass. Just for the thieves out there..
by tune4food
Wed May 13, 2009 6:00 pm
Forum: s300 / SManager
Topic: New to S300
Replies: 6
Views: 2928

The logs do not show a "twiddle" in the rpm at 6k.. it actually goes all the way to my limiter.. which is 7000. I'm going to plug in another gauge cluster or try out and independent tach see if it's the gauges.
by tune4food
Wed May 13, 2009 2:25 am
Forum: s300 / SManager
Topic: New to S300
Replies: 6
Views: 2928

got the AC working.. box was checked off in hondata to shut it off at 3500 rpm. So I raised the rpm to 5500. I don't know what type of wiring issue I could have because none of the wires are spliced.. I'm the only owner of the car, everything worked fine before I swapped out the ECU's.. so ur thinki...
by tune4food
Mon May 11, 2009 11:30 pm
Forum: s300 / SManager
Topic: A/C problem
Replies: 8
Views: 3426

There is a setting that disables A/C at a certain rpm. Set the rpm high to where u can use the AC...
I think it's setup that way so that if and when you decide to floor it, it turns off AC function so you have less parasitic drag from the engine.
by tune4food
Mon May 11, 2009 5:25 pm
Forum: s300 / SManager
Topic: New to S300
Replies: 6
Views: 2928

i didn't change anything in the wiring.. it was working previously with the obd2b p75. I got the wiring harness conversion (obd2-> obd1) and plugged in p28 with hondata in it. then after i loaded the basemap from hondata menu, changed the injector sizes... revved it.. and it wouldn't rev past 6k.. o...
by tune4food
Sun May 10, 2009 12:40 pm
Forum: s300 / SManager
Topic: constant CEL
Replies: 4
Views: 2519

does the tach completely not work? or does it stop working in the middle of an rpm? mine's doing the same thing.
by tune4food
Sun May 10, 2009 4:45 am
Forum: s300 / SManager
Topic: New to S300
Replies: 6
Views: 2928

New to S300

I have a 2000 LS integra with a B18B. Bought an S300 unit and a P28 to go with it. I have the obd2b -> obd1 jumper harness. I loaded the p74 basemap and played around with the tuning a bit considering the mods. Engine runs fine. My question is, I had AC problems to where it wasn't blowing cold air, ...