Search found 7 matches

by K24Zivic
Mon Sep 05, 2016 8:45 am
Forum: Fit 2007-2008
Topic: Swapping a 08 Civic SI into 07 fit
Replies: 3
Views: 4385

Re: Swapping a 08 Civic SI into 07 fit

Yes, and it runs daily.
by K24Zivic
Thu Sep 18, 2014 11:07 pm
Forum: Non-Hondata
Topic: dies after reving and drops when holding constant throttle
Replies: 5
Views: 5713

Re: dies after reving and drops when holding constant thrott

Have you set the idle with Idle Air Control valve disconnected? Is the TPS calibrated correctly? Have you checked for vacuum leaks? What's the fuel pressure doing? Where is the timing set?
by K24Zivic
Thu Sep 18, 2014 10:59 pm
Forum: Non-Hondata
Topic: 04 Element
Replies: 1
Views: 3140

Re: 04 Element

Check engine light? How many miles are on the engine? When were the spark plugs serviced and if they were recently, what brand of plug?
by K24Zivic
Thu Sep 18, 2014 10:44 pm
Forum: Fit 2007-2008
Topic: Swapping a 08 Civic SI into 07 fit
Replies: 3
Views: 4385

Swapping a 08 Civic SI into 07 fit

I am swapping the complete drivetrain and engine from a 08 Civic SI into a 07 Fit. I have modified the original fit engine harness into the K20 engine assembly, that's pretty straight forward. My concerns are at the ECU end. I will be using both the Civic and Fit ECU. I will be using the drive by wi...
by K24Zivic
Thu Sep 18, 2014 10:03 pm
Forum: K-Pro Calibrations
Topic: How to use a 05 RSX transmission with KPro
Replies: 0
Views: 2270

How to use a 05 RSX transmission with KPro

So, a long time ago I asked if there is a way to use KPro and a 05 RSX transmission. Turns out there is... You have to add a S2000 gauge cluster. The S2000 uses a high frequency vehicle speed sensor, like the one found in 05+ RSX. So, you run the signal wire from the speed sensor to the S2000 cluste...
by K24Zivic
Wed Aug 12, 2009 5:39 pm
Forum: K-Pro Calibrations
Topic: K24A4 with 05 RSX Transmission
Replies: 3
Views: 2834

Is it possible to use a PRB ECU with the calibration for a K24A4 entered into a RSX-S calibration file and get a low frequency speed signal output from the high frequency 05 RSX VSS?
by K24Zivic
Fri Jul 31, 2009 9:26 pm
Forum: K-Pro Calibrations
Topic: K24A4 with 05 RSX Transmission
Replies: 3
Views: 2834

K24A4 with 05 RSX Transmission

Is there any way to enable the K24A4 calibation with the ability to use the VSS on a 05 RSX transmission. Currently I am just converting a RSX map to the K24A4 calibrations, however this time consuming and leaves lots of room for error.

Thanks