Search found 18 matches

by civic EK sir
Sat Aug 15, 2020 10:14 am
Forum: S300 Calibrations
Topic: b16a with 440cc injectors base map needed
Replies: 2
Views: 4106

Re: b16a with 440cc injectors base map needed

you can try this map

as Ed says you should have wideband + injector data.
by civic EK sir
Sat Aug 15, 2020 10:08 am
Forum: SManager Display Templates
Topic: My Templates
Replies: 0
Views: 5056

My Templates

this is the template i use
by civic EK sir
Sat Jun 13, 2020 2:32 pm
Forum: s300 / SManager
Topic: TPS not reading any values...
Replies: 7
Views: 1068

Re: TPS not reading any values...

when you install the sensor back make sure it fits in between the fork so it will move as the throttle move.

then do the TPS scale.
by civic EK sir
Thu May 28, 2020 12:44 pm
Forum: S300 Calibrations
Topic: b20v looking for base map or mild tune?
Replies: 13
Views: 5911

Re: b20v looking for base map or mild tune?

Do you have any Log with any tuning file
by civic EK sir
Thu May 28, 2020 11:32 am
Forum: S300 Calibrations
Topic: b20v looking for base map or mild tune?
Replies: 13
Views: 5911

Re: b20v looking for base map or mild tune?

civic EK sir wrote: Thu May 28, 2020 11:14 am try this with 440cc
check your AF and inj duty if it go 90% switch to the 440
the attached Map for 240 cc
by civic EK sir
Thu May 28, 2020 11:14 am
Forum: S300 Calibrations
Topic: b20v looking for base map or mild tune?
Replies: 13
Views: 5911

Re: b20v looking for base map or mild tune?

try this with 440cc
by civic EK sir
Sat May 09, 2020 1:05 pm
Forum: s300 / SManager
Topic: Wont start, im out of ideas, getting gray hairs
Replies: 3
Views: 452

Re: Wont start, im out of ideas, getting gray hairs

from your data, it shows the AF 10.2 look like the fuel is to mutch and it will kill your spark plug

the thing you need to check

did you set inj data?

your map sensor set as 4 bar?? or stock map

do you hear the fuel Pump priming?

from online ---> test ECU output

Regards
by civic EK sir
Sun Apr 12, 2020 2:00 pm
Forum: S300 Calibrations
Topic: Air fuel mixture
Replies: 8
Views: 5082

Re: Air fuel mixture

it should be in 15-14.7 idle and low load
if you run 12 -11 your spark plug will not last +you wash-off that protective layer of oil in cylinders.
I recommend you check the spark plug to see the fuel mixture sometime one injector can cause your AF to go to12-11.
by civic EK sir
Sun Apr 12, 2020 1:47 pm
Forum: S300 Calibrations
Topic: Air fuel mixture
Replies: 8
Views: 5082

Re: Air fuel mixture

it should be in 15-14.7 idle and low load
by civic EK sir
Sun Apr 12, 2020 10:48 am
Forum: S300 Calibrations
Topic: need some help looking for a basemap
Replies: 1
Views: 1493

Re: need some help looking for a basemap

hi, it will be hard to find a similar setup. if you have a wideband connected to ECU I can help. you need your injector data=>set your TPS and the timing + some protection. start with low-speed fuel(disable the Vtec) then move to high speed. Note: the timing is Low in this base map it will build mor...
by civic EK sir
Sun Apr 12, 2020 12:06 am
Forum: s300 / SManager
Topic: Help with tune and calibration... Please
Replies: 4
Views: 518

Re: Help with tune and calibration... Please

Hi what normally I do at high speed (vtec) change the RPM index starts from 4600 any point below that is waste and you will not use. then increases by 200 rpm the benefits are captured more points and apply the change as needed, in your file it shows 500rpm that gives you 9 point to adjust only. (49...
by civic EK sir
Sat Apr 11, 2020 2:05 pm
Forum: s300 / SManager
Topic: Help with tune and calibration... Please
Replies: 4
Views: 518

Re: Help with tune and calibration... Please

the map is affected based on your location .i can is 2 deg as long as you don't have any issues (Knock)

you are ok your spark plug is your guide.

I suggest you may modify the load and rpm index to capture more point since you set point for vtec is 4900 .

good luck.
by civic EK sir
Mon Apr 06, 2020 9:52 am
Forum: s300 / SManager
Topic: Wiring up AEM 30-0300 wideband, need help!!
Replies: 23
Views: 6298

Re: Wiring up AEM 30-0300 wideband, need help!!

the best location for the ground is thermostat housing to avoid the voltage offset
as it in the instruction (The wideband should always be grounded to the same point as the ECU (the thermostat housing).
by civic EK sir
Mon Apr 06, 2020 9:27 am
Forum: S300 Calibrations
Topic: Forged css b16a2 turbo china gt3582r bosch ev14 1000cc injectors 9.0.1
Replies: 7
Views: 1571

Re: Forged css b16a2 turbo china gt3582r bosch ev14 1000cc injectors 9.0.1

Hi

you should set some Protection Parameters (Lean protection)

make sure you're wideband working fine
target AF is 11.5 in boost side.=option> sitting >target lambda
Set boost cut to 4 PSI

and you will be in the safe side
by civic EK sir
Thu Oct 13, 2011 8:36 am
Forum: S300 Calibrations
Topic: B20\B16 head 440cc map
Replies: 1
Views: 2237

B20\B16 head 440cc map

hi,
this map been requested from tuner before
B20\B16 head + 440CC injectors low resistance ,
4-2-1 hedars,Iceman Cold Air Intake.

appreciation your feedback if you download it.