Hondata

I have another problem. Last week I bought a new Netbook and proceeded to install KManager V1.4.5 BETA. Since then I've noticed my Short Term Fuel Trim is way out causing a Long Term Fuel Trim. This is usually at '0%'. The Long Term is 'positive' at idle, 'negative' at low load, and OK at a higher ...

I have another problem. Last week I bought a new Netbook and proceeded to install KManager V1.4.5 BETA. Since then I've noticed my Short Term Fuel Trim is way out causing a Long Term Fuel Trim. This is usually at '0%'. The Long Term is 'positive' at idle, 'negative' at low load, and OK at a higher l...

Hi, Just back from a quick run. These are the errors I got within a 5 minute period... Access violation at address 0047B256 in module 'KManager.exe'. Read of address 08FE4DF8. Access violation at address 0047B42C in module 'KManager.exe'. Read of address 08E1BD38. Access violation at address 0048066...

The .INI file has : TableType=0 TableCamAngleIndex=3 TableHighSpeedCam=0 Change by zero but didn't work.. acces violation again... :( I did the same last night and still the problem persists. I am using a new netbook running Windows 7 32-bit starter edition. English UK. The error even appeared with...

Hondata,

Is this version of KManager compatible with Apple's operating :?:

rikitaun & VT-Doo : do you still get the access violation error with the beta version? If so, then please can you email us the KManager.ini file? Will do. With the time difference and the fact I've just started work it may seem like I'm taking my time about it :roll: English UK is foreign :?: Scott...

English UK is foreign :?:

Windows 7 64-bit

Sometimes when I'm accessing a calibration I get an error. I also had this error every 30 seconds while datalogging today. The error reads, "Access Violation at address 00430853 in mobile 'MKanager.exe". Write of address 00000024". For me it wasn't with PRA calibrations. I have a PRC ECU and was tr...

Hi,
Is there an update due soon as I still can't get the the latest beta to work correctly?

Cheers,

How are you guys getting on with the reported bugs?

Sometimes when I'm accessing a calibration I get an error. I also had this error every 30 seconds while datalogging today.

The error reads,

ERROR MESSAGE wrote:"Access Violation at address 00430853 in mobile 'MKanager.exe". Write of address 00000024".

Why isn't this the same as in SManager?

I can't seem to see where the corrections are.
In the S300 I'm using it great, but even looking at the "sensors" window in KManager there is no corrections being displayed for water or air temperature.

Can you please show me where it is, or at least a picture of it within KManager?


Cheers,
Ian

You can but it's not recommended as it is possible to corrupt the calibration currently in the ECU.
You should have got a copy of the calibration after it was mapped. Contact the person who mapped your car.