Hondata

Yes I will contact him soon. Before I will damage the engine.
I don't know which settings I must increase/decrease to make the engine lean/rich in MAF setup. :-(
So I will pay money again again and again.........

Update from my side:
700cc is the correct value of fuel consumption on the dash.
After 420 / 450 km the dash drops into the red zone and the re-fuel symbol popsup. It matches also with the bill's :) Thanks for the fix!

Thanks for your answer.
Ok I will check the fuel and I will re-test again.
The air intake to the supercharger is stock - normally all is secure and closed (tight?) correctly.
Only a Scoop-in after the airbox is installed to get cold fresh air.

Hi Hondata,

see attached files below.
Thanks for help.

Hi Hondata, If the engine is cold (in the morning) in low rpm and speed-up it is a little bit jerki to drive. But if I reach ~2.600 rpm all is normal. Any idea which option I must tune to fix the "jerki" speed-up? I think all is default at the moment because I don't know which setting I mu...

Yahhh Hondata, it works fine :) At the moment I am testing with the 750 / 749cc value. Maybe the 770 is the correct value for the Rotrex S/C K20. More details in next weeks... Feedback: The consumption with 800cc values are a little to high which is displayed on the board computer. In normal drive w...

My fuel tank was very empty at this morning. I could not trust the fuel gauge so I will refuel today and then I take a look of the ride bar if correct. :-D
And I am back in the action!

It takes ca. 1 minute, Not longer! I was in trouble with my USB stack - it cause the problem. It was fixed very easly after troubleshooting. > I unplugged two more devices - after that it was finished very fast. Thanks Matthias ;) Here my results: with 800cc in both fields: DSC_0001.JPG DSC_0002.JPG

How long the Power-LED from the FlashPro will blinking in firmware update mode? After installing the Testversion of flash pro manager the flash pro needs a firmware update... How long it takes, approximately? Previously v2.1.3 was installed - Ok it is finished. 20 minutes after start it was finished...

I think:
http://www.deatschwerks.com/products/fu ... 0-4-detail

800cc Fuel Injectors
Product SKU: 21U-01-0800-4

Hondata, please confirm.

Hi, Test looks very good I will test the new version on Sunday evening my car is currently in the fair: tuning world bodensee 2015 Hondata can you post the dimensions of your dw 800cc injectors and their clips please? So we can check if it possible to change the injectors to the DWs without modify t...

Here in Germany, we must note that we retain the emission levels! No, the Map is the same before / after! With the MAP-Cal I have about 1 liter less fuel consumption with the same driving style and the power/the torque is higher. Seen overall, the performance and power delivery is better / higher! ...

Hmm Ok, so I can not provide the requested datalog. Hondata I hope it is possible for you to find the solution without the datalog from us.

Nuno and Hondata, if i use my tuned AFM-Map with importet fuel tables of my MAP-Cal, is this ok, or I have to tune new my MAF-Cal with the MAP-fuel tables? Since i have installed my Exedy stage 1 clutch, when I push the clutch and drive very slowly (role), than the engine speed goes under idle spee...

Unfortunately I can not provide a Datalog with this setup which you have requested. :-( Maybe you can compare it with the U.S. Civic SI car? In advance thank you very much for your support and to find a solution. Edit: Please check the website here: http://flashprotuning.com/infamous-edyno/requests ...