Hondata

ok thanks for all the help...
anyway im not using it for butterfly, i used it for boost control and it works ....i know sound crazy but it works....

so if i connected to the injector feeders i have to use resistor block? what if i dont have one?

is it steeper motor or solenoid?
where do i get the 12v?from the ecu or batt?
if from the bat what fuse do i use?

ur running very lean(18.43afr) and hot(106.6F)? check your wideband connection and ur setting ...

is the s300 tune for your car? bcoz in order to make it work right on ur car must tune by a tuner or u with a laptop and a wideband

make sure u dont have thermostat or u have on it, i have the same problem b4 but after changing the thermostat everything is okey now....

try check yur oil level and add a little bit than normal level....i know this becaused it happen to me b4 my oil level was low so it wont let me go to hi cams which is my vtec point....

i know thats the problem too it doesn't show on the datalog what makes the engine rev limit, the map and tps sensor plug are in the right place and my ground on the thermostat is good too.. my car doesn't rev limit below 50% of throttle but when i over 50% the engine revlimit and when i let the peda...

set up gsr fully built top and bottom w/type r cams new ngk spark plug bkr7e gap to .30" and new spark plug wire tdo4 tubo wish to boost 9 2.5" stright pipe w/n1 muffler i just got the s300 install on my ecu and tune at part throttle everything is good but everytime i try to run to high rp...

go to parameter, den closed loop, by wideband input source change to D10 ELD....

That datalog looked perfectly fine as far as reading AF ratios. You aren't making any boost. yes im not making any boost because im trying to tune for no boost for now.... i noe the afr look alryte but look at the end of the datalog lambada voltage(0.00v) and input wideband (4.98v) are different......

sorry.thanks

im having a problem with the reading of the afr because my input from my wideband is showing 4.98v (22.39 afr) but in smanager it show 0.00v (7.35 afr)...everything went wrong after updated to beta 1.4.3...i also tried used D14 but still the same... Setting frm analog 2 input:b6 removed r2,r3 0v=7.3...