Hondata

Hondata wrote:You're not going to ask for this on the 2013 Si?

LOL ... not yet!

Nice!

I've attached 3 datalogs that demonstrate the issue. Datalog 1 was recorded just after uploading a calibration with live tuning enabled on throttle vs flow Datalog 2 was recorded just after making a significant change to the throttle vs flow table - After making the change to the table, I cleared DT...

The table itself does work, but the changes made using Live tuning do not have any impact. The changes don't actually get applied until the full calibration is reflashed. While dialing in my cold and warm starts with A/C on and off, lights on and off, etc., I was using several tables in Live tuning ...

I initially reported this last year in this thread , then reported (incorrectly) that it was working after all. However, I know now that I was just getting the Civic and S2000 mixed up. It turns out that live tuning of Throttle vs Flow does NOT work for the '13 Civic Si, but it does work for the S20...

Oh snap! I just noticed that the datalog has -20 degrees for cam angle, so it's being filtered out! After changing my cam angle filter to include -50 to 50, all the fuel adjustments showed up!

I think all those settings are in the INI file I exported, and attached to a post above. However, here are some screen shots.

They are both open. I am able to live tune while datalogging, but I just can't see the suggested fuel changes.

I just now got the sensor overlay to work, but still not the "Display fuel adjustment values" view.

Are you able to view the suggested fuel adjustments?

I was able to view some data using the sensor overlay, but not the A/F value. I have tried various settings for the Wideband input, but haven't found one that works.

Could it be my settings in KManager? Here is my ini file.

Here is the calibration.

Here is a datalog...

It is an AEM UEGO wideband connected to Analog 0 (KPro 4). The KPro reads the value fine, and is using it for closed loop operation without any issues.

I'm doing a tune for ITB's in an S2000 with KPro with Alpha-N, and can't figure out how to get KManager to display suggested fuel changes on the fuel tables. I'm not able to view the sensor overlay either. Any suggestions?