Hondata

i manage to get it working now.

No anti virus programs on this laptop.
Its a dell Running windows 7

How does this look?

All was done in 4th gear.

I reloaded 3.2.2 and took a screen shot, as you can see the error message.
The error message only appears when I plug the USB into the laptop, the ign does not need to be on either.

are you guys looking into this?

The above question.

can you post what should be used?

i did what you guys mention on page one and my dead times where very close to IDs times.

I reset all the fuel maps back to where they where before and used both 1000 and 800 and still got the same lean readings. I bump up the fuel because i didn't want to drive the car with it being so lean (17:1) and set the dead times and they are not far off from the ones located on IDs web page. My ...

My car is also a EDM but it's right hand drive, LHD is similar with same connections, it will be by the driver's accel pedal.

E29 seems to be the simplest in my opinion and the connection is right by the driver's clutch pedal, kinda.

Just needs a ground.

Guys, I installed my ID1000cc injectors this morning, I changed the sized in the parameters and started the car, it fired up like it still had in the 310cc BUT now my A/F gauge which once read 13-14AFRs is now at a steady 17. All of this on idle with no other mods done to the car as yet. UPDATE: I b...

can Hondata have a section in the downloads where you can select past version of the software?

my last version was 3.2.0 but i can only download 3.1.6

Guys,

I tried the beta 3.2.2 and now im able to load my PRA files but when its connected to the vehicle it give me an error, i think it was something to the tune of kmanager had to close, i have to reinstall 3.1.6 again to regain any communication with my ECU.

Ok guys seeing these cams are bigger on the intake high side in both lift ad duration and bigger primaries on the exhaust side my question is: using these cams on a K20A2 internally stock motor will I be able to safely reuse my VTC gear up to 50 degrees without any contact?

Thanks

...

Thanks arno, that's exactly what's happening.

I'm using a PRA ecu