Hondata Boost Solenoid

Hondata model coverage & ECU application questions.
Post Reply
sergiokazoom
Posts: 27
Joined: Sat Aug 19, 2017 10:01 am

Hondata Boost Solenoid

Post by sergiokazoom » Sun Aug 20, 2017 8:26 am

If i have a 4port boost solenoid hooked up per hondata instructions and wanted to run off of the wastegate would i just set the kpro boost control settings to "Maximum Boost at 100% Duty/Normally Closed" ?
And do i also still have to disconnect the vacuum hose going to the top of the wastegate if i set it to Normally closed and wanted to run off of just wastegate pressure?

User avatar
Spunkster
Site Admin
Posts: 17940
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Hondata Boost Solenoid

Post by Spunkster » Mon Aug 21, 2017 10:24 am

Just set it to 1% duty cycle and it should have such a small effect that it will run off the wastegate spring. Or if you really want to run off of the wastegate spring, just disable boost control.

sergiokazoom
Posts: 27
Joined: Sat Aug 19, 2017 10:01 am

Re: Hondata Boost Solenoid

Post by sergiokazoom » Tue Aug 22, 2017 7:02 pm

Thanks for the reply. But i thought if you disabled the boost controller it would set you up at maximum boost? If you disable it dont you have to remove the vac hose on top of wastegate and plug it?

User avatar
Spunkster
Site Admin
Posts: 17940
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Hondata Boost Solenoid

Post by Spunkster » Wed Aug 23, 2017 9:39 am

It is a normally closed solenoid, so it will go to the wastegate spring.

Post Reply