idle surge after reflash

Questions / support for the K-Series ECU re-flash
Post Reply
fneri95
Posts: 2
Joined: Tue May 19, 2020 5:55 pm

idle surge after reflash

Post by fneri95 »

Hondata

I have a 2006 Honda Civic Si, k20z3. car has headers and full 3" exhaust. Car ran perfect and purchased the hondata reflash in March of this year. Once I installed the ecu again when I turn the car on and engine reaches warm running temperature idle begins to surge, 700-1000 rpm besides that while driving car runs great, vtec activates around 4500 rpm, redlines near 9000 rpm. Replaced spark plugs to see if that was the issue but no success. looking for any advice or solution to this. Thanks
User avatar
Spunkster
Site Admin
Posts: 22740
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: idle surge after reflash

Post by Spunkster »

Have you tried cleaning the throttle body or anything?
fneri95
Posts: 2
Joined: Tue May 19, 2020 5:55 pm

Re: idle surge after reflash

Post by fneri95 »

Yes cleaned the throttle body and it helped a bit but after a while begins to surge again while stationary. Seems as if it’s not receiving enough air flow at low rpm.
User avatar
Spunkster
Site Admin
Posts: 22740
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: idle surge after reflash

Post by Spunkster »

You may need to clean it again and then do the factory idle learn procedure.
Post Reply