IAT & ECT Correction Display

VT-Doo · Post by **VT-Doo** » Fri Mar 26, 2010 5:36 am

I can't seem to see what the current IAT/ECT Corrections are which are being applied to the map within Sensors or Display.

Am I missing something or doesn't it exist? It comes in handy with the S300.

Thanks,

Post by **Spunkster** » Fri Mar 26, 2010 1:49 pm

When datalogging look at the parameters. You will need to make sure that you go to Options, Settings, Display and enable the parameter table tracing.

VT-Doo · Post by **VT-Doo** » Wed Nov 17, 2010 5:44 am

I can't seem to see where the corrections are.
In the S300 I'm using it great, but even looking at the "sensors" window in KManager there is no corrections being displayed for water or air temperature.

Can you please show me where it is, or at least a picture of it within KManager?

Cheers,
Ian

Post by **Spunkster** » Wed Nov 17, 2010 10:23 am

Corrections cannot be seen in the sensor list. You will have to look at your corrections in parameters and see how they are set.

VT-Doo · Post by **VT-Doo** » Fri Nov 19, 2010 5:37 am

Why isn't this the same as in SManager?

Post by **Spunkster** » Fri Nov 19, 2010 10:14 am

Different ECU hardware and software . It is completely different and does not have these parameters in the data stream.