Upgrading to Kpro4

[slamedsedan]

I would like to upgrade to Kpro v4. do i just fill out the form and mail it with my v3 and money order? or do i have to go through a dealer? any info would be great!

[Spunkster]

You do not need to go through a dealer. You must send payment, the form and the ECU with the K-Pro to be upgraded.

[insomnia]

Hi there,
Calibration of v3 is functional upgrading to version 4? Is it necessary to modify it?
Regards

[Spunkster]

The calibrations are the same between all K-Pro versions. You should not need to make any changes.

[insomnia]

Between PRA and PRB too? Between PRB- and PNF?

Thanks

[Hondata]

Between the KPro, KPro-II, KPro3 & KPro4 the calibrations are the same. Between the PRA, PRB, PND & PNF there are differences, but in any case the calibration will load the binary it is associated with and no other.

[insomnia]

So... You need PRB v4 to copy from PRB v3 for example...
It would be interesting , a table in which hear cases where it is possible to switch between versions (from/to PRA, PRB, PND & PNF)

Regards

[Rxanthony77]

Hi I have a quick question, if I send in my old kpro unit in, can you copy my current kal on there and paste it to the kpro v4 upgrade? Please let me know thank very much

[Hondata]

With every upgrade we copy the calibration over. However, if the ECU security was set then we can't read out the existing calibration and have to use a default calibration.

[Rxanthony77]

Thanks for quick replied, my kpro is version 1, so it should be no security lock right? And what the time turn around after I send it in pleSe let me know thank u so much

[Hondata]

Turn around time is around 2 days. We do a lot the same day, but sometimes we only receive USPS/FedEx/UPS at 2pm, and they pick up at 4pm, so they go out the next day.

[Honda]

Can i upgrade my kpro v2 ecu to kpro v4 to greek local dealer?

[Spunkster]

No, this must be done directly with Hondata.

[Rxanthony77]

Thanks I just sent my kpro out off my civic si today, hopefully I get it back early next week , also I wanna know if possible to upgrade my other kpro in my tsx?

[olivenoire]

A great thing should be you to allow european dealer to upgrade directly without sending ecu in USA
It cost 110€ (probably 140$) and it is impossible to be sure everything will be fine during this "trip"

in this case, is the 250$ +50$ upgrade is good for you to send in europea the ecu+kprov4???
what in case of control, import taxes etc?