Kpro not connecting to laptop
Posted: Sat Feb 20, 2016 3:16 pm
Ok I have a kpro V4 upgraded around January last year.
2006 Rsx-S
Turbo
Kmanager 4.2.3 or the latest one out. Just recently swapped cams and wired in PLX wideband to chassis, no data logging wire to Ecu yet.
Tried to start my car on the old calibration and car wouldn't run without foot on the gas. Then my check engine light came on. So I rushed off to grab my laptop to see what the code was. Found out then that my Ecu wasn't connecting to my laptop. Started going through my list of things to do:
Reinstalled drivers
Tried different laptop
Added extra grounds around the engine and chassis
Checked resistance on grounds and injector ground
I pulled the kpro down from the factory Ecu mount to pull the cover and inspect the board to see if it was loose. So I tried the key on the inspect the green and red LED's while the cover was off.
My green LED comes on for a brief moment when the key is turned on but then goes off. And the red LED is very very faint when the datalog cable is plugged in.
Please help me. I feel I've done all I can and that there is an issue with the kpro
2006 Rsx-S
Turbo
Kmanager 4.2.3 or the latest one out. Just recently swapped cams and wired in PLX wideband to chassis, no data logging wire to Ecu yet.
Tried to start my car on the old calibration and car wouldn't run without foot on the gas. Then my check engine light came on. So I rushed off to grab my laptop to see what the code was. Found out then that my Ecu wasn't connecting to my laptop. Started going through my list of things to do:
Reinstalled drivers
Tried different laptop
Added extra grounds around the engine and chassis
Checked resistance on grounds and injector ground
I pulled the kpro down from the factory Ecu mount to pull the cover and inspect the board to see if it was loose. So I tried the key on the inspect the green and red LED's while the cover was off.
My green LED comes on for a brief moment when the key is turned on but then goes off. And the red LED is very very faint when the datalog cable is plugged in.
Please help me. I feel I've done all I can and that there is an issue with the kpro