Injector driver question
-
- Posts: 36
- Joined: Fri Jun 18, 2004 12:40 pm
- Location: vegas
Injector driver question
I'm interested in building a bi-fuel car using Kpro and injector driver using CNG as main fuel and e85 for higher powered driving. My question is could I write a program that would run ONLY on the secondary injectors were I to run out of gas or for what ever reason wanted to run only on e85?
Re: Injector driver question
No, the software was designed to run staged injectors where either the primary injectors are running, or both the primary and secondary injectors.
Hondata
-
- Posts: 36
- Joined: Fri Jun 18, 2004 12:40 pm
- Location: vegas
Re: Injector driver question
1.5 years later and were at this again.
With 2 injector drivers can driver #1 run low impedance main injectors and driver #2 run secondary additional set? Run with Kpro v4
With 2 injector drivers can driver #1 run low impedance main injectors and driver #2 run secondary additional set? Run with Kpro v4
Re: Injector driver question
The KPro can only run high impedance injectors. If you ran a second set of injectors then they can be either off or on but the KPro controlled injectors will always be running.
Hondata