hello,
at first i thought it was an injection problem but turns out my map sensor is fully in vac.
dosnt matte what sensor i use nor if i pull wiring out of plug it shows neg 29psi..
is this a bug?
i just done an update
cheers
Kpro bug? Map sensor not functioning
Re: Kpro bug? Map sensor not functioning
Not a bug. Are you sure the map sensor has not been damaged, the ECU 5V output is ok, and that your sensor setup is ok?
Hondata
Re: Kpro bug? Map sensor not functioning
Hello thanks for the reply.
I believe the TPS and map sensor plugs have been swapped by mistake. Could this cause it?
5v on feed. 4.7 on signal 0 on ground
All without map sensor plugged in.
Even with sensor unplugged it’s showing -29.
Running ktuned 4 bar. Have omnipower / hondata 4 bar selected.
I’ve tried resetting etc but didn’t help.
I believe the TPS and map sensor plugs have been swapped by mistake. Could this cause it?
5v on feed. 4.7 on signal 0 on ground
All without map sensor plugged in.
Even with sensor unplugged it’s showing -29.
Running ktuned 4 bar. Have omnipower / hondata 4 bar selected.
I’ve tried resetting etc but didn’t help.
Re: Kpro bug? Map sensor not functioning
If you can, measure the voltage at the ECU with the MAP sensor plugged in.
Hondata
Re: Kpro bug? Map sensor not functioning
Have you swapped the plugs back to the correct locations?