PS Pump Switch - E16

K-Series Programmable ECU installation questions / support issues
Post Reply
AngryScottish
Posts: 25
Joined: Mon Dec 07, 2015 10:53 am

PS Pump Switch - E16

Post by AngryScottish »

ECU: KPro V4

Before I go about reinventing the wheel (pun not intended), I have a Mini Cooper EHPS pump installed. It currently runs whenever the ignition is on. After fiddling with some wiring diagrams... I noticed that pin E16 is for the PS Pump switch...

I'm not sure how the original system functioned, so sorry if this is remedial. But, could I use that to control my EHPS pump, by wiring that to a relay to power the pump on/off?

User avatar
Spunkster
Site Admin
Posts: 18140
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: PS Pump Switch - E16

Post by Spunkster »

No, that is an input to the ECU to idle up slightly when the pressure increased to keep it form stalling the engine.

AngryScottish
Posts: 25
Joined: Mon Dec 07, 2015 10:53 am

Re: PS Pump Switch - E16

Post by AngryScottish »

got it, thanks for the super quick reply!

Post Reply