Plx dm6 to prb kpro v4 ep3
Plx dm6 to prb kpro v4 ep3
Hi, just bought plx dm6 multigauge and lambda sensor.
I wonder how to connect it to ecu? I think that i take old lambdas off and put the car workin only with plx wideband.
I wonder how to connect it to ecu? I think that i take old lambdas off and put the car workin only with plx wideband.
Re: Plx dm6 to prb kpro v4 ep3
Do you want to run closed loop from the aftermarket wideband or do you just need it for datalogging?
Re: Plx dm6 to prb kpro v4 ep3
I want to run closed loop
Re: Plx dm6 to prb kpro v4 ep3
You will have to wire the wideband signal into the analog input on the K-Pro board and then configure the analog input settings for your wideband. Then go to the closed loop settings and select the option to run on an external wideband.
Re: Plx dm6 to prb kpro v4 ep3
Digital input works great as well, I've been running that for years now.
Re: Plx dm6 to prb kpro v4 ep3
Does anybody have did this? Im wondering how to do wiring job correctly.
Re: Plx dm6 to prb kpro v4 ep3
I+ and G on the kpro board connects to TX on the PLX module.
- Attachments
-
- kproplx.jpg (86.48 KiB) Viewed 2623 times
Re: Plx dm6 to prb kpro v4 ep3
Thanks a lot. I Will test it soon
Re: Plx dm6 to prb kpro v4 ep3
Hi, i took my old lambda out and put plx in. I selected external wideband in k-manager options. But now it gives p1166 trouble code. (Primary O2-sensor heater)
What causes this?
What causes this?
Re: Plx dm6 to prb kpro v4 ep3
Try unchecking the enable sec O2, FTP, PA and ELD in the Misc section.
Re: Plx dm6 to prb kpro v4 ep3
Digital input did not work on my hondata with plx dm6, i think i will test analog input. Can someone tell what settings i have to select In k-manager?
Re: Plx dm6 to prb kpro v4 ep3
You just need to set the analog input to the PLX in the parameters for analog input.