Commanded air fuel not matching tables

K-Series Programmable ECU installation questions / support issues
User avatar
Hondata
Site Admin
Posts: 10434
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Commanded air fuel not matching tables

Post by Hondata »

Because commanded lambda is not the same as target lambda. The ECU does not target commanded lambda. It is just an adjustment.
Hondata
h2.4
Posts: 22
Joined: Fri May 29, 2009 2:06 pm

Re: Commanded air fuel not matching tables

Post by h2.4 »

Ok, Thank you for clearing that up. So when logging the "fuel adjustment values" that are populated by the ecu, those percentage corrections are based off of the "Target Lamda tables" still though? If that is true, then I guess I can disregard the Com Lamda channel that I was seeing in the log not matching the Target table.
User avatar
Hondata
Site Admin
Posts: 10434
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Commanded air fuel not matching tables

Post by Hondata »

Yes, suggested adjustment is based of target lambda.
Hondata
Post Reply