Aim mxs 1.2 kpro v3 issue

[Undefined4door]

Hi I have a kpro v3 and aim mxs 1.2 strada, I have the aim mychron board wired to the gauge cluster and to the appropriate pins on the ecu a24 and e24. I set up the multiplexer to 9600bps and used the aim program to configure to hondata kpro ecu. I am currently not getting any data on the gauge besides voltage. Any help is appreciated!

[Spunkster]

Have you read the info in the help file: http://www.hondata.com/help/kmanager/mu ... =multiplex

[Undefined4door]

Hi spunkster yes I have, and have set up the multiplexer per aim instructions. 9600 bps with pin connected to e24.

[Undefined4door]

Is there a way to verify im getting proper output out of e24 with a voltmeter or scope?

[Spunkster]

You will need a logic analyzer to test that.