Questions on resistor for oil temp sensor.

K-Series Programmable ECU installation questions / support issues
Post Reply
tbc
Posts: 3
Joined: Fri Oct 08, 2021 8:15 am

Questions on resistor for oil temp sensor.

Post by tbc »

I purchased a combination sensor with both temperature and pressure function. Based on Hondata's help page, it mentioned that A 1.5k ohm (1500 ohm) 1% resistor must be used between the analog input and 5V.. Looking through sensor's data sheet indicated 4.6K pull up resistor under unloaded resistance Vs temperature data table.

Question is which resistor should I use? What does unloaded resistance mean in the given table?

http://www.hondata.com/help/kmanager/in ... wiring.htm

Image
Post Reply