Kpro v4 Launch control N/A setup

K-Series Programmable ECU Calibration updates / downloads
Post Reply
jdouille
Posts: 15
Joined: Tue Mar 12, 2019 3:19 am

Kpro v4 Launch control N/A setup

Post by jdouille »

Hey Hondata.

Honda k20a2 EUDM 2002 Ep3
CAI
Skunk2 ultra street intake manifold
Race header Piper (no catalyst)
Exhaust 60mm Piper
Hondata kpro v4 242ch / 231nm map
Internal stock
Fuel Sp98

In Launch control parameters my launch start at 4500 rpm but it's very slow Bop........... Bop...........Bop........... and others parameters, Fuel enrichment and ignition retard are 0 Units.

With N/A setup it's posible change this Enrichment and Ignition retard for most fast, short Launch, brap..brap..brap.. brap.. without breacking the engine or exhaust ?

Thanks, best regards

User avatar
Spunkster
Site Admin
Posts: 18635
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Kpro v4 Launch control N/A setup

Post by Spunkster »

Changing the ignition and fuel values for an NA vehicle will not make any change to the speed at which it operates.

jdouille
Posts: 15
Joined: Tue Mar 12, 2019 3:19 am

Re: Kpro v4 Launch control N/A setup

Post by jdouille »

So, on NA engine there is no way to change or any modification the launch control ?

User avatar
Spunkster
Site Admin
Posts: 18635
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Kpro v4 Launch control N/A setup

Post by Spunkster »

Not to make it any faster as you are not spooling a turbo with exhaust gases.

Hpmengine
Posts: 25
Joined: Thu Sep 05, 2019 5:22 am

Re: Kpro v4 Launch control N/A setup

Post by Hpmengine »

HI guys

Even Big Flames can be done faster ...... but in K it is somewhat more difficult in S300 in NA it is very simple and in Turbo easier still ..... The problem with Kseries is static values (behind MAP )
S300:
https://www.youtube.com/watch?v=OYRR4hEpqaM

ANOTHER ANGLE

https://www.youtube.com/watch?v=ZH8EsSz_LSg

In the K-series it is somewhat less because of what was mentioned before ...

Regards

Post Reply