i need kal k20a2 ITB OBX

K-Series Programmable ECU Calibration updates / downloads
Post Reply
rinkana-k20
Posts: 3
Joined: Wed Aug 05, 2015 4:45 am

i need kal k20a2 ITB OBX

Post by rinkana-k20 » Wed Aug 05, 2015 5:09 am

I have a honda civic ep3 engine k20a2, compression 11,2:1 with gasket Spoon, kit cams and ratainers BCrower stage 2, kit valves Ferrea, fidanza flywheels, cluntch stage 4, gerabox with final drive 5.1 and LSD DC5, Header PLM with catback full titanium interior 63mm, PRB Kpro V4, ITB OBX Individual throttle body 52mm and injector RC440, fuel regulator pressure gauge K-Tuned, fuel pump grams 320l/h ...
I live on an island and I have not tuned Hondata nearby. I need a base map and a trainer also online ( I pay ) to put just my car .

rinkana-k20
Posts: 3
Joined: Wed Aug 05, 2015 4:45 am

Re: i need kal k20a2 ITB OBX

Post by rinkana-k20 » Mon Apr 11, 2016 7:43 am

hi.. I ran the first start.. i used a base map of Kmanager... someone can take a look?
Attachments
Kmanager data 2.kdl
(2.21 MiB) Downloaded 83 times
Kmanager itb 48mm.kal
(161.87 KiB) Downloaded 106 times

ce
Posts: 36
Joined: Fri Jan 31, 2003 12:46 pm
Location: Denmark
Contact:

Re: i need kal k20a2 ITB OBX

Post by ce » Fri Apr 22, 2016 10:36 pm

I'd recommend you use the alpha-n calibration in kmanager instead. Much better. I've been tuning Hondas with ITBs since early 04 and alpha-n or pure tps like used in Motec and other universal systems is by far the best compared to MAP with ITBs

Do you have access to a dyno ?
K is king

jdm_boi
Posts: 2
Joined: Sun Jan 29, 2017 9:09 pm

Re: i need kal k20a2 ITB OBX

Post by jdm_boi » Sun Jan 29, 2017 9:39 pm

ce wrote:I'd recommend you use the alpha-n calibration in kmanager instead. Much better. I've been tuning Hondas with ITBs since early 04 and alpha-n or pure tps like used in Motec and other universal systems is by far the best compared to MAP with ITBs

Do you have access to a dyno ?

just jumping in on this thread. do you teach how to tune? I'm willing to pay also for the lesson and i have access to dyno. thanks.

rinkana-k20
Posts: 3
Joined: Wed Aug 05, 2015 4:45 am

Re: i need kal k20a2 ITB OBX

Post by rinkana-k20 » Mon Feb 06, 2017 1:36 pm

I have finished with my K20a2 .. what do you think?
Attachments
AS-TPS-9 kdl.rar
(324.99 KiB) Downloaded 70 times
AS_TPS_9.kal
(159.26 KiB) Downloaded 86 times

Post Reply