In need of a basemap
-
- Posts: 3
- Joined: Sat Apr 01, 2017 5:50 pm
In need of a basemap
As title states I am in need of a basemap to get my car running and to the tuner. It's a k24a2 with cp 10.9:1 pistons and cp rods,a k20 head, k20 cams, rbc intake manifold, 4 inch cai and r crew swap header. Any help will be appreciated
-
- Posts: 100
- Joined: Thu Jul 14, 2016 12:32 pm
- Location: Fresno,Ca
Re: In need of a basemap
I recommend having a wideband so you can adjust afr to spec espcially if your gonna full throttle. I also assume you are using the stock 310cc injectors. I advice having the stock o2 sensor plugged/installed so it will help trying to hit 14.7 daily portion.
- Attachments
-
- k24 Base.kal
- *I will not be responsible for any damage done*
- (170.26 KiB) Downloaded 146 times
-
- Posts: 3
- Joined: Sat Apr 01, 2017 5:50 pm
Re: In need of a basemap
I got the car running good, I was trying to set up a button for launch control and accidentally wired it to a22 pin on the harness instead of the e22 and now the car won't start. A22 is afshtct (+)...hoping I didn't burn out my ecu I checked the ecu fuse and it's good so idk what else it could be
Re: In need of a basemap
If you have uploaded a calibration that you know works and you have wired something incorrectly, you should try the ECU in a known working vehicle and see if it will start and run. If it does not, then it sounds like you have damaged the ECU from improper wiring.
-
- Posts: 3
- Joined: Sat Apr 01, 2017 5:50 pm
Re: In need of a basemap
Figured it out it was my main relay