K24A3 using PND-V4 and 5 speed

K-Series Programmable ECU Calibration updates / downloads
Post Reply
CHB
Posts: 44
Joined: Sat May 27, 2017 12:31 am

K24A3 using PND-V4 and 5 speed

Post by CHB » Sun Oct 14, 2018 7:26 pm

Hi Hondata,
I have recently swapped a K24A3 into my RSX Base with 5 speed transmission.
Everything were transferred over from K20A3 to the K24A3 (everything on PRB intake manifold, knock sensor and coolant temp sensor, and crank angle sensor).
Do I need to change anything else apart from enrichment to compensate the extra capacity?

I just need to start the engine and make sure everything else is good before drive it to my tuner (50km away).

Thanks

User avatar
Spunkster
Site Admin
Posts: 17744
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: K24A3 using PND-V4 and 5 speed

Post by Spunkster » Mon Oct 15, 2018 9:26 am

That should get it to start and then you can fine tune it. You can also try contacting the tuner for a base calibration to get it to the dyno.

Post Reply