Page 1 of 1

K24A3 using PND-V4 and 5 speed

Posted: Sun Oct 14, 2018 7:26 pm
by CHB
Hi Hondata,
I have recently swapped a K24A3 into my RSX Base with 5 speed transmission.
Everything were transferred over from K20A3 to the K24A3 (everything on PRB intake manifold, knock sensor and coolant temp sensor, and crank angle sensor).
Do I need to change anything else apart from enrichment to compensate the extra capacity?

I just need to start the engine and make sure everything else is good before drive it to my tuner (50km away).

Thanks

Re: K24A3 using PND-V4 and 5 speed

Posted: Mon Oct 15, 2018 9:26 am
by Spunkster
That should get it to start and then you can fine tune it. You can also try contacting the tuner for a base calibration to get it to the dyno.