Page 1 of 1

Tune out initial throttle sensitivity.

Posted: Sat Oct 20, 2018 3:53 am
by HumblePie
K20A2 EP3 Type R Euro, AEMV2, S90 76mm Throttle body, RRC Ported, Piper sports cat, DC Sports.

My S90 Tb is a bit tricky.
It seems my foot is not as sensitive as the initial throttle response of the S90.
What this means is, when i pull off from a junction i usually end up revving it too far and pulling off when the revs return.
Unfortunately i don't wan't that kind of attention in traffic.
If i don't do this, then i am trying to tickle the throttle pedal, which inevitably leaves me slow to pull off in traffic followed by the inevitable rev.

Can this be tuned out and how would i do this?

If anyones advice can stop me looking like a dufus i would appreciate it.

Re: Tune out initial throttle sensitivity.

Posted: Mon Oct 22, 2018 10:45 am
by Spunkster
The ECU has nothing to do with the throttle sensitivity. This has to do with the throttle itself.

Re: Tune out initial throttle sensitivity.

Posted: Sun Nov 04, 2018 7:44 am
by HumblePie
Can I reduce the fuel table at the start of the map or will this cause an issue?

Re: Tune out initial throttle sensitivity.

Posted: Tue Nov 06, 2018 10:14 am
by Spunkster
Ignition timing would have more of an effect, but will probably not effect it much, but you can try.