need a cali for the 2 following specs. just to have them running smoothly on k-pro when the new ecu comes in so i can get street tuned. but i dont want to run lean with just the k20a3 on high octane tune...with the rev limiter set at what i was told would be 7700 or 7600 to be a safe range on the a3 with my supporting mods (all motor). the 2nd tune is for the somewhat Cybernation Stage 2 kit going back on the car the 3rd weekend in march. i was previously running guardian EMS and i dont particularly trust a self tuning piggyback system so i swaped injectors and spark plugs and need the first tune asap if possible and the second on ehhhh in a few weeks. thx guys.
keep in mind...im in germany....and where im at there is no dynos in my area.
if i cant get a custom tune from you guys then what is the closest calibration you have?
1st Calibration:
2003 US Spec Si
K20a3 38,000 mi.
S2000 Valves and Retainers
AEM SRI
Hondata K-Pro (of course)
Hondata IMG
DC Sports Shorty 4-1 Ceramic Header
Megan Test Pipe
APEXi N1 Catback
2nd Calibration:
Same car
S2000 Valves and Retainers
RC 650cc Injectors (12ohm)
Hondata K-Pro (of course)
Hondata IMG
APEXi N1 Catback
Denso IK24 Irudium Plugs (1 Step Colder than Stock)
Turbonetics (Standard) T60-1 Turbo
Spearco Bar & Plate FMIC (Rated at 600hp)
Cybernation FMIC piping with all blue silicone couplers/clamps
Cybernation Custom Turbo Manifold
Cybernation 2.5" Downpipe
Greddy Type S BOV
Turbonetics Deltagate Wastegate w/7lb Spring
Need 2 calibrations
Re: Need 2 calibrations
still need a turbo calibration...
GOT AN N/A Calibration ... thx ephatch :P
2nd Calibration:
Same car
S2000 Valves and Retainers
RC 650cc Injectors (12ohm)
Hondata K-Pro (of course)
Hondata IMG
APEXi N1 Catback
Denso IK24 Irudium Plugs (1 Step Colder than Stock)
Turbonetics (Standard) T60-1 Turbo
Spearco Bar & Plate FMIC (Rated at 600hp)
Cybernation FMIC piping with all blue silicone couplers/clamps
Cybernation Custom Turbo Manifold
Cybernation 2.5" Downpipe
Greddy Type S BOV
Turbonetics Deltagate Wastegate w/7lb Spring[/quote]
GOT AN N/A Calibration ... thx ephatch :P
2nd Calibration:
Same car
S2000 Valves and Retainers
RC 650cc Injectors (12ohm)
Hondata K-Pro (of course)
Hondata IMG
APEXi N1 Catback
Denso IK24 Irudium Plugs (1 Step Colder than Stock)
Turbonetics (Standard) T60-1 Turbo
Spearco Bar & Plate FMIC (Rated at 600hp)
Cybernation FMIC piping with all blue silicone couplers/clamps
Cybernation Custom Turbo Manifold
Cybernation 2.5" Downpipe
Greddy Type S BOV
Turbonetics Deltagate Wastegate w/7lb Spring[/quote]