I put my car in open loop and drive to see how my calibration is doing in every day traffic and tune my part throttle.
In addition to that I do a third gear pull and tune again.
Can you please take a look at my calibration and datalogs?
I see a few -19, -43, -68 in my long drive data log and need advice?
I am not sure if you need this, I will post this anyway:
Voltage / Lambda conversion table
0.00 V > 10.000 AFR
0.50 V > 11.000 AFR
1.00 V > 12.000 AFR
2.00 V > 14.000 AFR
And voltage offset -0.24 V
Thank you very much in advence.
Regards.
How am I doing?
-
- Posts: 39
- Joined: Mon Jul 07, 2008 2:09 pm
How am I doing?
- Attachments
-
[The extension exe has been deactivated and can no longer be displayed.]
2002 Euro Civic Type R
KPro (SN:05506, HW Ver.:2.16, FW Ver.:2.02)
Hondata Heat Shield Gasket
BDL 66mm Throttle Body
Fujita F5 Cold Air Intake
Toda Headers
Mugen Power Mid Pipe and Twin Loop Rear Silencer
AEM UEGO 30-4100 Wideband Controller
KPro (SN:05506, HW Ver.:2.16, FW Ver.:2.02)
Hondata Heat Shield Gasket
BDL 66mm Throttle Body
Fujita F5 Cold Air Intake
Toda Headers
Mugen Power Mid Pipe and Twin Loop Rear Silencer
AEM UEGO 30-4100 Wideband Controller