Issues with Display for pressure sensor 0-100psi data.
Issues with Display for pressure sensor 0-100psi data.
I previously had my display settings set up for my oil and fuel pressures set up under analog 1 and 2. using autometer 2246 pressure sensors. on my display they use to show the psi conversion. but since the new update they seem to only show me voltage now. Is there a way to switch it?
Thanks in advance.
Thanks in advance.
Re: Issues with Display for pressure sensor 0-100psi data.
From Help, About, what is the version of software you are using?
Re: Issues with Display for pressure sensor 0-100psi data.
id have to look when i getback to the house. left the laptop at home. I just remember the update being from March 11th this year.
Re: Issues with Display for pressure sensor 0-100psi data.
It is version 2.7.6.0
Re: Issues with Display for pressure sensor 0-100psi data.
Please download the most recent version
Re: Issues with Display for pressure sensor 0-100psi data.
So i updated to 2.7.7.0 and still no luck. also ive been having an issue with the engine not revving past 2500 rpm. i had a feeling it is a corrupt file on the s300. so i built a new tune and uploaded it to the ecu with the key on engine off. then turned off and turned back on. went to download the tune to make sure it took and i got nothing.
my s300 serial # 50559
my s300 serial # 50559
Re: Issues with Display for pressure sensor 0-100psi data.
Post your calibration and a datalog showing the issue.
Who socketed the ECU?
Can you post pictures of the soldering on the bottom of the ECU?
Who socketed the ECU?
Can you post pictures of the soldering on the bottom of the ECU?
Re: Issues with Display for pressure sensor 0-100psi data.
I honestly have no idea who socketed the ECU I purchased it second hand.
it was working just fine for months.
i also just found under s300 information that the datalog memory test failed and flash memory
it was working just fine for months.
i also just found under s300 information that the datalog memory test failed and flash memory
- Attachments
-
- Hondata 50559.png (58.28 KiB) Viewed 1487 times
-
- test.s3d
- datalog
- (215.37 KiB) Downloaded 84 times
-
- NEW B20 BASEMAP.skl
- calibration
- (47.11 KiB) Downloaded 85 times
Re: Issues with Display for pressure sensor 0-100psi data.
Send an email to support<at>Hondata.com with the following and I will issue an RMA and give you further
instructions:
Name:
Address:
Phone:
Email:
Serial#:
Description of problem:
Include a link to this thread
instructions:
Name:
Address:
Phone:
Email:
Serial#:
Description of problem:
Include a link to this thread
Re: Issues with Display for pressure sensor 0-100psi data.
About to send it out. But I was going to ask as well. I had purchased a Digital dash to run over CAN and I’ve had nothing but issues with it since day one. I was curious if I was about to send it in with the ecu and Hondata to figure out what was going on with it not communicating.
Re: Issues with Display for pressure sensor 0-100psi data.
We have no way to test an aftermarket dash with the K-Pro.
Re: Issues with Display for pressure sensor 0-100psi data.
Are you able to test if there is signal coming for the CAN? also it’s S300
Re: Issues with Display for pressure sensor 0-100psi data.
Sorry, I meant s300. We have no way of testing the CAN outputs at this time.
Re: Issues with Display for pressure sensor 0-100psi data.
S300 CAN output tested and working as expected.
Hondata