ELD wire?
ELD wire?
trying to hook up my eld wire with the wideband output wire from the plxm300 on an obd2b hondata ecu. ecu is chipped for s300. narrowband wire from plx is going to stock o2 sensor connector in engine bay. everything is hooked up accept the wideband output wire from the plx and i guess i am suppose to hook it up to the eld wire. which one is this or any help would be greatly appreciated......thanks
http://www.hondata.com/techwiringgsr.html
ELD wire must be disconnected from the actual ELD so the ecu is not getting that signal
ELD wire must be disconnected from the actual ELD so the ecu is not getting that signal
Last edited by Spunkster on Wed Jan 25, 2006 4:52 pm, edited 1 time in total.
RE: ELD
OK, maybe i am confused of what the actual "ELD" is. once this eld wire is disconnected, do i hook up the wideband output from the plx device to the eld which i just disconnected?
in other words what is the eld and where can i find it. thanks agian!!!!
in other words what is the eld and where can i find it. thanks agian!!!!
re: dj
alright, first off, thanks for your help....i get that i need to cut the wire going into d10. but my ecu doesnt have a "D" plug. only has an A,B,and C.....i have a p28 obd2b w s300. i have searched my ecu and found out that A30 is my "eL" (electronic load detector) wire. The connection where "D" goes is empty, there is no harness that goes to d"???? thanks for all the help.
----------------or i could just find the eld in the engine bay at the fuse box and cut it there and then hook up the wideband there?
----------------or i could just find the eld in the engine bay at the fuse box and cut it there and then hook up the wideband there?
your ecu actually has A, B, and D... C is missing :) a few special application ecus came with it. you are in no way the first to make that mistake.
RaVer Motorsports (559) 733-4711
ravermotorsports@earthlink.net
ravermotorsports@earthlink.net
re:
if that were true that would be very helpful but here is the other side of the fact that is confusing me.....
here is my ecu and exactly what my ecu looks like p28obd2b
http://www.hondaswap.com/forums/index.p ... post&id=34
here is my ecu and exactly what my ecu looks like p28obd2b
http://www.hondaswap.com/forums/index.p ... post&id=34
sorry, i didn't realize you had an obdI ecu with the obdII plug on it. obdIIa vs obdIIb is the issue you are having... one lacks C the other lacks D. check the pinout for the other and you'll see what i mean :)
hope that gets you going.
hope that gets you going.
RaVer Motorsports (559) 733-4711
ravermotorsports@earthlink.net
ravermotorsports@earthlink.net