how do i get psi to show in the table ?
how do i get psi to show in the table ?
i have it set to show psi but it is only showing mbar can anyone help?
Same problem - help please!
I have the same problem, I changed the units to psi on the settings window and then selected the show boost table but still cant get the table to show psi values. This might be a dumb question as only one thread appeared on the search, but can somebody let me know how to change the units form mbar to psi on the table?...smanager version is 1.3.6.0.
Thanks in advance!
Thanks in advance!
Re: how do i get psi to show in the table ?
Upperguy wrote:i have it set to show psi but it is only showing mbar can anyone help?
Do you mean when youre viewing a datalog ? I am having this same issue . Whenever i review a datalog it always shows in mbar instead of psi . Perhaps someone can chime in and help ?
-
- Posts: 39
- Joined: Sat Jun 14, 2008 9:45 am
- Location: tx
options
settings
then click units. its the 2nd tab.
then in vacuum pressure the first box,
click "inch"
go to the next box pressure unit,
click "Pounds per square inch (psi)"
then click "ok"
be sure in the other box "vacuum unit base"
click absolute(increase from full vacuum)
"pressure unit base"
click "Atmoshperic (atmoshperic=0)
i think that should solve your problems, if its not your not doing something right
settings
then click units. its the 2nd tab.
then in vacuum pressure the first box,
click "inch"
go to the next box pressure unit,
click "Pounds per square inch (psi)"
then click "ok"
be sure in the other box "vacuum unit base"
click absolute(increase from full vacuum)
"pressure unit base"
click "Atmoshperic (atmoshperic=0)
i think that should solve your problems, if its not your not doing something right
Still Can't
I must have something wrong here...can someone tell me (check the print screen)...I can't see the table in psi after the changes in the settings tab. Thanks again!
- Attachments
-
- smanager.jpg (384.39 KiB) Viewed 5463 times
Re: Not yet!
Agreed , im in the same boat .yakito wrote:Still can't...I can only see vaccum on the boost tables, Does it has to be online for it to show psi?....Thanks for all the help.
Frankie