injector question

laziebun · Post by **laziebun** » Wed Sep 05, 2007 7:26 pm

i about to purchase s300 and wondering if my injectors will work precision 780cc with a resistor box??? in a 99 honda civic gsr swap obd1

Tchleung · Post by **Tchleung** » Wed Sep 05, 2007 8:18 pm

as long as the PTE's are peak and hold, why not?

Post by **Hondata** » Thu Sep 06, 2007 8:53 am

If at all possible use high impedance injectors - they work better than peak and hold injectors.

JT · Post by JT » Thu Sep 06, 2007 10:14 am

If the original setup is peak & hold with a resistor box, do you need to take out the resistor box when switching to high impedance injectors?

Post by **Spunkster** » Thu Sep 06, 2007 10:45 am

Yes you do. YOu can depin the clip the resistor box plugs into and swap it to an OBD1/OBD2 style distribution block that uses the end cap that ties all the wires together.

boostedcivicsir · Post by **boostedcivicsir** » Thu Sep 06, 2007 8:52 pm

if you are usint the factory green plug on the resistor box, an obd0 dual point dizzy connector works also.