s300 and SManager software questions & answers
Right i did this, but now my problem is i don't know how to get the Hondata software to read it.hiperformance wrote:White 0-5V Output from wideband - connect to ELD input making sure that the ELD is no longer connected to it (ELD is pin D10 on an OBD1 ECU)
In other words, cut it.
I've gone into close loop mode and told it the calibrations.
But i want to also monitor it as a sensor to make sure it is reading right.
The only "display" i can get is the "lambda" 1, but this isn't as an AFR (which i prefer) and it doesn't seem to correspond to the D10 pin.
Would it be easier just to choose a new pin? As i want to autotune and display wideband as an AFR on the screen.
Also the ECT (engine coolant temp) sensor isn't calibrated correctly it seems, as the engine was just started and was showing 100 degrees (celcuis) 170 ish F. How do i calibrate this sensor?
I've read those and installed it.Spunkster wrote:The instructions for this are pretty much the same for the LC1: http://www.hondata.com/techplxwiring.html
What i want to know is how i get to see what the wideband is doing on my laptop.
If i click the lamda button it displays the lambda figure but it doesn't tell me as an AFR to compare it to my gauge, even when i worked it out the figure wasn't the same as displayed on my XD16.
I guess it must be the voltage offset i need to change.
When i've got this working, how do i enable auto tune?