s300 and SManager software questions & answers
- Posts: 5
- Joined: Tue Dec 04, 2007 10:32 am
- Location: NW Indiana
P28 ecu have been using s300 for about year now. the last up date changed the values in the vlotage/lambda conversion table. the question is why is there 3 boxes now for voltage? i changed the setting to 0v = 10.00 and 5v = 20.00 but what goes in the 3rd option? voltage settings are for a PLX wideband.
the setting that opened after the update were 0v=1.47 5=.73 and 5=.73
- Site Admin
- Posts: 8753
- Joined: Thu Aug 15, 2002 12:13 pm
- Location: Torrance, CA
This is for lambda meters which have a non-linear voltage output. In your case, leaving the last two columns the same will work for you.
- Posts: 104
- Joined: Fri Jul 14, 2006 11:49 am
it´s not possible to set it to 0V@0.5 and 5V@1.52. it always jumps to some crazy values! everytime when i have learned the handling with smanager, hondata changes it!
- Posts: 6
- Joined: Fri Mar 07, 2008 10:05 pm
are you entering them in the 1st and second columns, or the first and third?
i had the same issue until i entered a middle value on the second column