Page 1 of 1

Vacum index flipped around??

Posted: Wed Jan 14, 2009 1:50 pm
by inspector01
So i had Smanager on my Vista laptop before and it worked fine, than I added AVG and it did that thing, but I fixed it as instructed and Smanager is back, however now my Vacumm index is switched around-- col 1 is -3.4" vac, col 9 is -28.7" vac -- then col 10 is .5 psi, and boost is fine from there up. Any ideas why this is?? I haven't gotten to connect to a car, but everything else looks the exact same (fuel and ignition values ect...) , the vacum index is just backwards.

BTW, it is like this on every bin that I open, even brand new ones, not just one bin.

Posted: Wed Jan 14, 2009 2:13 pm
by Spunkster
Go to Options, Settings, and make sure you have the units set correctly.

Posted: Wed Jan 14, 2009 7:38 pm
by inspector01
Haha, I feel like an idiot. I had checked to make sure it was still in inches, but i didn't pay attention to that vac unit base was absolute. Changed that to atmospheric and that took care of it. Thanks.