Hello,
A friend of mine has bought a S200 for his B16A2 engine with P30-G00 ecu.
He ask me too install it. And too program the ecu on the dyno.
I have read all the page's on hondata about the S200.
Is it right that I can only datalogging with S200 and not programming
the ignition and fuel maps directly with the S200 interface?
When I read it right I need too program the ecu with a emulator.
So that is what I also normally do when I chip a car.
But my friend has bought this system so he can make by him self changes
in the ignition and fuel maps.
Is it right that he must buy then the S300?
Thanks,
Rudy
S200 Options
Oke I will discuss with him about the S300.
I read the website a few times but I can't really read what the S200 is doing.
What does the S200 exactly? Datalogging?
We have the S200 but do I need it too program the ecu?
If i have a emulator and romeditor 4 then I can program the car where
is the S200 then for?
Is the S200 used for tracing from the maps?
Do I need a special base program too use romeditor 4?
Do I have too pay for romeditor 4?
Can you give a short answer on all my question's.
I think it will help a lot people too clear this out.
Thanks,
Rudy
I read the website a few times but I can't really read what the S200 is doing.
What does the S200 exactly? Datalogging?
We have the S200 but do I need it too program the ecu?
If i have a emulator and romeditor 4 then I can program the car where
is the S200 then for?
Is the S200 used for tracing from the maps?
Do I need a special base program too use romeditor 4?
Do I have too pay for romeditor 4?
Can you give a short answer on all my question's.
I think it will help a lot people too clear this out.
Thanks,
Rudy