PLX M-200 kit installation problems
Posted: Mon Mar 29, 2004 7:00 am
I have a 96 GSR with a conversion harness for a odbI P28 Ecu. I have 4 wires on the plx. red and black of course power and ground. And white and Gray.. The intructions say to use white for the o2 signal ( pin-out# D22 I think on the ecu? ) Nothing in any of the hondata nor the PLX instructions explain what to do with the gray wire.
I thought it was a green and white wire i was supposed to connect it to but it doesnt seem to work. I have tried real hard to find a pin out diagram for a p28 ecu so I would know which pin I need to tap the wideband o2 signal (white wire) into.
ANy links to a good howto on this?
Oh I forgot to add; I used to have an air/fuel ratio meter hooked up to the black wire down by the o2. (this is the plug that plugged into the plug for the original o2 sensor) I tried the white wire on that old connection knowing its going to the right pinout of the ecu and that didn't work either.
The reason I think its the right one is, my air/fuel ratio meter worked fine off this wire , thats why I am assuming its the signal one.
I thought it was a green and white wire i was supposed to connect it to but it doesnt seem to work. I have tried real hard to find a pin out diagram for a p28 ecu so I would know which pin I need to tap the wideband o2 signal (white wire) into.
ANy links to a good howto on this?
Oh I forgot to add; I used to have an air/fuel ratio meter hooked up to the black wire down by the o2. (this is the plug that plugged into the plug for the original o2 sensor) I tried the white wire on that old connection knowing its going to the right pinout of the ecu and that didn't work either.
The reason I think its the right one is, my air/fuel ratio meter worked fine off this wire , thats why I am assuming its the signal one.