Need basemap for built gsr b18c n/a

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Post Reply
Johnnyed9
Posts: 1
Joined: Wed Oct 14, 2015 6:03 am

Need basemap for built gsr b18c n/a

Post by Johnnyed9 » Wed Oct 14, 2015 9:05 am

Need a basemap, have following mods

Benson sleeves bored .080 over
Cp pistons 12.5 cr
Manley hbeam rods
Titanium dual valve springs and retainers
Oversize intake and exhaust valves
70m skunk2 throttle body
Skunk2 alpha intake
Skunk2 alpha exhaust
Skunk2 stage 2 cams
Id1000 injectors
Full port and polish intake,exh,throttlebody

Any more info needed let me know

st333v03
Posts: 1
Joined: Fri Oct 21, 2016 4:25 pm

Re: Need basemap for built gsr b18c n/a

Post by st333v03 » Sat Oct 22, 2016 11:57 pm

did anyone get back to u with a base map for your set up?

Zperformance
Posts: 100
Joined: Thu Jul 14, 2016 12:32 pm
Location: Fresno,Ca

Re: Need basemap for built gsr b18c n/a

Post by Zperformance » Sun Oct 23, 2016 7:00 pm

Hey load this map up see how it do. Adjust Afr to spec timing map is retard a tad bit to compensate for your higher compression since im assuming you are running 91 octane. Let me know how it do and if you need anymore help.
Attachments
Built GSR Basemap.skl
*Use at your own risk*
(45.5 KiB) Downloaded 122 times

Post Reply