B16a 2nd gen Engine:
-Skunk2 camshaft tuner stage 2
-skunk2 camgear
-skunk2 pro intake manifold
-skunk2 titanium retainers
-skunk2 valve spring
-CTR Piston w/ new rings
-ACL main&rod bearings
-ARP head stud&rod bolts
-blueprinted block
-OBX throttle body
-ITR airbox with air duct to bumper, k&n filter
-toda replica stainless steel header
-ITR helical lsd
-9lb flywheel
-stage 1 excedy clutch kit
-RC 330cc injector
need a basmap asap, thanks.....
B16A2 semi allmotor build map needed
-
- Posts: 100
- Joined: Thu Jul 14, 2016 12:32 pm
- Location: Fresno,Ca
Re: B16A2 semi allmotor build map needed
Adjust AFR to spec. Let me know how it does this is a descent basemap to get you up and running. Let me know how it do!
- Attachments
-
- B16 built basemap.skl
- *Use at your own risk*
- (45.75 KiB) Downloaded 524 times
Re: B16A2 semi allmotor build map needed
i install your map, the start up is good. only feel like misfire at idle, maybe because i didn't degree the cams yet.
tomorow i'm goining to let the cams be degreed, will try it again.
tomorow i'm goining to let the cams be degreed, will try it again.
-
- Posts: 100
- Joined: Thu Jul 14, 2016 12:32 pm
- Location: Fresno,Ca
Re: B16A2 semi allmotor build map needed
Do you have a wideband?
Check your distributor timing.
Check your distributor timing.
Re: B16A2 semi allmotor build map needed
No i dont have a wideband yet.
And the old owner had the dizzy full advanced.
But tomorow i'm going to the dyno.
And the old owner had the dizzy full advanced.
But tomorow i'm going to the dyno.
Re: B16A2 semi allmotor build map needed
thanks, the car is running great now..
-
- Posts: 100
- Joined: Thu Jul 14, 2016 12:32 pm
- Location: Fresno,Ca
Re: B16A2 semi allmotor build map needed
That is great to hear! What are your #'s?