H22A ALL MOTOR ITBS BASEMAP NEEDED

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Post Reply
Kroy4king
Posts: 4
Joined: Sat Mar 18, 2017 2:14 am

H22A ALL MOTOR ITBS BASEMAP NEEDED

Post by Kroy4king »

Hi everyone

I've just rebuilt my H22A and it's running like a bag of shit.

Engine: H22A/ stroked to H23
Compression: 12:7:1
Cylinder head: Full Ferrea Valve Train with 1mm+ oversized valves, ported and polished with a 5 angle valve job, with stage 2 skunk2 cams
Exhaust: Skunk2 mega power 3" system all the way through.
Intake: 52mm OBX ITBs
Injectors: SARDS 800cc
Balance shaft delete
Lightened pulleys
MSD kit
Fuel system: Walbro 340l pump with Skunk2 high flow rail
Map sensor: 4 bar hondata


If anyone can help me out it would be much appreciated
Zperformance
Posts: 100
Joined: Thu Jul 14, 2016 12:32 pm
Location: Fresno,Ca

Re: H22A ALL MOTOR ITBS BASEMAP NEEDED

Post by Zperformance »

Adjust the AFR to spec with a wideband.
Attachments
Basemap for Kroy.skl
*i will not be responsible for any damage*
(41.49 KiB) Downloaded 292 times
Kroy4king
Posts: 4
Joined: Sat Mar 18, 2017 2:14 am

Re: H22A ALL MOTOR ITBS BASEMAP NEEDED

Post by Kroy4king »

Zperformance wrote: Sun Mar 19, 2017 5:49 pm Adjust the AFR to spec with a wideband.
Hi mate thanks for the help with the map, unfortunately the engine just didn't like running the ITBs so I've taken them off and put a skunk2 manifold with a 70mm throttle body on to run the engine in and ill try to put them back on over the winter time.

Don't suppose you got a basemap I could use with the change in intake manifolds?

cheers
Zperformance
Posts: 100
Joined: Thu Jul 14, 2016 12:32 pm
Location: Fresno,Ca

Re: H22A ALL MOTOR ITBS BASEMAP NEEDED

Post by Zperformance »

What AFR are you seeing?
Post Reply