Page 1 of 1

D16A6 Calibration

Posted: Tue Jan 08, 2019 3:46 pm
by Turbocivic6776
I am trying to figure out what basemap I should use to start with. I currently have the car running off of the p28 basemap but am unsure if this is the same timing as the A6 map would have since this map is actually for a SOHC V-tec. I assume the timing is the same since only the cylinder head is different and it just wont ever enter the secondary tables. I have already disabled V-tec in parameters too. I would just like to confirm this before I push my car any further. Any help is appreciated. Thanks

Re: D16A6 Calibration

Posted: Wed Jan 09, 2019 10:37 am
by Spunkster
YoOu can use it as a starting point, or start with a P06 calibration which is non-vtec.