Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
2 posts • Page 1 of 1
Alright so I've been doing various tunes for a while now, and while it's never been an issue, I've always noticed the software automatically bumps values up by xx number. Say I'm in the closed loop advanced parameters page, and I set the voltage values to 0.00, 2.50, and 5.00. Well, 0 and 5 stay fine, but 2.50 will automatically bump up to 2.51, and it just sets my OCD off. Anyone have any ideas how to stop it from doing this, or will I just have to deal with it?
This is the nature of the values as they are not stored in the ECU as the exact value you can enter. This is completely normal and just how it works.