Page 1 of 1

D16Z6 Turbo calibration ?

Posted: Wed Nov 01, 2006 1:31 pm
by Nagata-San74
Does anyone of you have a basemap for this basic setup ?


D16Z6
T3/T4 .63
440cc RC
255l/h Walbro
2,25 piping
7psi



HELP ! :?

Posted: Wed Feb 21, 2007 7:07 pm
by Spanky
buy a wide band o2 sensor/controller. your new best friend. idle will be your biggest trick, but closed loop takes care of itself. you shouldnt go any leaner than 12.8:1 on 93 octane, especially on a stocker. as timing goes, 12-14 degrees atdc is easiest on your bearings, although you could make a few more hp at the sacrifice of longevity by increasing timing. i suggest plx m300 wideband o2. great bang for the buck, and its listed in the s300.