Hondata

I`m new here, please someone have a good base map for my B20vtec, this is the first engine in my country. This is my set up:
JE 85 mm pistons and rings 12.1:1 CR
Eagle connecting rods
B16A Head w/ARP head studs
Golden Eagle conversion kit
Buddy Club Dual Valves Springs
Buddy Club Titanium Retainers
TODA C cams
CTR Intake
ITR Header
70mm Edelbrok TB
Hondata S300
AEM Wide Band
CTR LSD
ITR final gear
Walbro fuel pump
440 cc injectors
Blaster SS Coil, MSD distributor cap

Thanks foy any help

dude,u have similar set up to mine except for the 85mm where i have 84mm 12.5:1CR & 310cc inj.. u can try this map i have but they r not 100% perfect. i have the toda c as well with ctr IM 70mm.
try that map and work from there.

thanks dude, im already install the new ecu, already load the base map but the engine don`t start up. My stock ecu is a OBD0 but the new OBD1 ecu is with OBD0-OBD1 harness and went TB is close TPS=91%, TB is open TPS=0% someone has same problem before? maybe i install my harness wrong way?

Sorry but my english is no good, i hope someone can help me

vteczone wrote:dude,u have similar set up to mine except for the 85mm where i have 84mm 12.5:1CR & 310cc inj.. u can try this map i have but they r not 100% perfect. i have the toda c as well with ctr IM 70mm.
try that map and work from there.

dude the low cam fuel map on that thing looks all screwed up.

can anyone share those calibrations with me again thanks!!! i got a similar setup to that one!!! thanks alot!!!

You still having trouble with this setup or have you figured it out?