I need a calibration for H22 turbo T3/T04

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Locked
dieguino
Posts: 4
Joined: Tue Oct 23, 2007 12:26 pm

I need a calibration for H22 turbo T3/T04

Post by dieguino »

I need a calibration for Prelude H22 with BOOST ( 10 psi) :!:

Does anyone of you have a calibration for this setup??

OBDI
H22 JDM
RC 440cc
CROWER Cramshafts Turbo Stage 2
Fuel Pump Walbro 255 LPH
Turbo T3/T4.63
ECU P30 with Hondata S300J
MAP Sensor Stock or 3bar MAP
Head Gasket for Low Compresion
2.5" strait pipe / 2.5" catback / removed AC

Write me please: diego.eguino@zurich.com

The past saturday I used the map of BEN ( PeakBoost_015) but its no so good for my lude...

Please help!
Thanks a lot! :D

deafy
Posts: 191
Joined: Mon Jul 10, 2006 6:22 pm
Contact:

Post by deafy »

Use the stock h22 base map and work from that. Definitely make sure you have a wideband o2 sensor. This is how i started out with my 550cc t3/t4 setup at 5.83 psi. Still haven't gotten it completely tuned yet but I will.
1997 Prelude - under the knife.
2000 Insight - k20z3 swap, pt6262, e85. 508whp@19psi.

dieguino
Posts: 4
Joined: Tue Oct 23, 2007 12:26 pm

Post by dieguino »

thanks.... but, if you have a base map for prelude turbo, please try to copy me your file.

deafy
Posts: 191
Joined: Mon Jul 10, 2006 6:22 pm
Contact:

Post by deafy »

I'd get it if i could, i just dont have access to a laptop, mine died shortly after I got a good tune set.
1997 Prelude - under the knife.
2000 Insight - k20z3 swap, pt6262, e85. 508whp@19psi.

Locked