Need a base map for b20vtec.

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Locked
frakinstine
Posts: 3
Joined: Wed Jan 11, 2006 7:30 pm

Need a base map for b20vtec.

Post by frakinstine » Wed Jan 23, 2008 4:52 pm

I have b20vtec with built bottom end and stock gsr head. Any fuel maps to start with would be nice. The motor is as listed.

bottom end bord to 85mm
wiseco 11.0- 12.0 compression range pistions
eagle connecting rods
gsr water pump
7 lbs flywheel
stock obd2 gsr head
stock gsr butter fly intake manifold
brospeed header
2-3/4" header back exhaust
skunk2 tunner cam gears
310 injectors
after market fuel pressure regulator
cold air intake
jdm typeR tranny and stage 5 clutch
a 255 walbro fuel pump don't remember what the shell came with
motor is about 12.4:1 compression

planetspeed
Posts: 72
Joined: Sat Jun 30, 2007 8:15 am

Post by planetspeed » Wed Feb 06, 2008 9:35 pm

Hi Spunkster/Hondata! any basemap on the above mentioned engine?Thank you.

User avatar
Spunkster
Site Admin
Posts: 17992
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Post by Spunkster » Thu Feb 07, 2008 12:45 pm

Go to File, New and start from one of the calibrations there.

peruvianB20vtec
Posts: 3
Joined: Tue Oct 23, 2007 12:19 pm
Location: Peru

Post by peruvianB20vtec » Sun Feb 17, 2008 8:33 pm

i run my b20vtec with this map, my set up is similar but i'm using 440 cc injectors, good luck
Spunkster wrote:Go to File, New and start from one of the calibrations there.
Attachments
COQUIB20VTEC.skl
(31.84 KiB) Downloaded 1214 times

hpmx18
Posts: 211
Joined: Tue Feb 17, 2009 6:47 am
Location: U.S.A

Post by hpmx18 » Tue Feb 17, 2009 6:52 am

peruvianB20vtec wrote:i run my b20vtec with this map, my set up is similar but i'm using 440 cc injectors, good luck
Spunkster wrote:Go to File, New and start from one of the calibrations there.
my setup is almost the same exept for 13cr n strocked with 550cc
can you post that map again

Locked