Hondata

Posted: **Tue Nov 11, 2008 1:01 am**

Hello all,

Engine spec:
Standard B16B bottom end.
Standard ITR head with flat face valves.
Standard 62mm ITR throttle body
370cc RC Injectors
JUN III cams

We are having problems tuning out the whole that has appeared when it changes from Low to High cam

Tried:
Moving v-tec change point
Changing back to 60mm CTR throttle body

Can anyone assist or even supply a calibration that may help?

Thanks
Brent

Posted: **Mon Jan 12, 2009 3:44 pm**

You got this in an EK9 then?

what wideband are you useing?

I'm sure I can help

Posted: **Sun Feb 01, 2009 8:48 pm**

OTT wrote:You got this in an EK9 then?

what wideband are you useing?

I'm sure I can help

No, its an EG4 with EK9 running gear basically.

Not sure what you mean by wideband, do you mean oxy sensor?

The guy that does my tuning suggested I post something on here to try & find some help.

Any help is appreciated.

thanks
Brent

Posted: **Mon Feb 02, 2009 7:53 am**

have you got an email?

Posted: **Mon Feb 02, 2009 12:55 pm**

Just sent you an e-mail from your website.

Posted: **Wed Feb 04, 2009 6:31 pm**

do you have any datalogs of this?

Posted: **Wed Dec 23, 2009 8:09 am**

B16B wrote:Hello all,

Engine spec:
Standard B16B bottom end.
Standard ITR head with flat face valves.
Standard 62mm ITR throttle body
370cc RC Injectors
JUN III cams

how did u go with the tune for the above set up? could u post the map for it?

Hondata

S300 calibration for JUN III cams

S300 calibration for JUN III cams

Re: S300 calibration for JUN III cams